You are not logged in.
Dear visitor, welcome to Aqua Computer Forum. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.
Yep, that's what is happening.... I have the MPS 400, connected via 4 wire Aquabus. And as I said when you enable it, you lose FAN1..... My MPS tab stays there in AS2012 when I disconnect it from USB and there is a big X in it and you can't do anything.......I begin to see the problem!
I have a mps 100 flow installed. When connected via USB, I have a tab for it in AS2012 that allows selection of the calibration curve.
When connected by 4 wire Aquabus and USB, I get the internal temp sensor values and the option of selecting a calibration curve.
When connected only by 4 wire Aquabus, I get only the option of selecting a calibration value, not the calibration curves. And of course, the seperate tab goes away in AS2012.
This is not good.
This post has been edited 6 times, last edit by "Jakusonfire" (Dec 31st 2012, 3:55pm)
-