You are not logged in.
Dear visitor, welcome to Aqua Computer Forum. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.
Quoted
Q1: Unsure what the Aquabus connects too. Do I connect that to the Multiswitch? If so, then what is the advantage as I understand I don't need the USB connection from the Multiswitch to the Mother board?
Quoted
Q2: What is the Expansion Slot ment to be connected too?
Quoted
Q3: Relay emergency shutdown, is this recommented and where do you get the cable for this?
Quoted
Q4: I assume that as the fans are infact small motors, I need to fit a self-induction recuperation diode and a 100 nF capacitor to the consumer to prevent intererences with the Mulitswitch, is this true?
Quoted
Q5: Will the Multiswitch allow me to change the voltages of the fans between 12v, 7.5v and 5v with the software interface, or is it simply 12v on and off? This allows me to change the fan speeds and so the sound output of the fans.
Quoted
Q6: The Aquastream connection is not used due to the Aquero connected to the Aquastream, is this correct?
Quoted
Q7: Unsure what the Aquabus connects too. Do I connect that to the Aquaero? If so will I loose some useful functionality in controlling the Jumper 3 (PWM function)?
Quoted
Q8: What device is the RPM-signal connection for?
Quoted
Q9: Do I connect that straight to the Mother board, and how does the Aquaero know if the water leaks out?
Quoted
Q10: Can you see anywhere where I have mis-understood the aquacomputer products and I am likely to damage anything?
Quoted from "Shoggy"
DO NOT connect the molex connector to the aquastream AND aquaero at the same time. This is only recommed if you encounter problems with the aquastream - most likely when you connect the tubemeter too.
-