Zitat

--------------------------------------------------------
1) Windows NT 4.0 and Windows 2000/XP Fresh Installation
--------------------------------------------------------
Follow the instructions in this section if you are performing a new
installation of Windows NT 4.0 or Windows 2000/XP, and you wish to
boot from a device attached to the SiI 3112 controller.


1. Power off the system.  Connect the hard drives to the SiI 3112
  controller and insert the controller into a PCI slot. Power up
  the system.

2. Put your Windows NT/2000/XP CD into the CD-ROM/DVD drive, or
  the NT/2000/XP boot diskette #1 in the floppy drive if your
  system cannot boot from the CD.

3. Press F6 for third party SCSI or driver installation at the beginning
  of text mode installation.  Press 's' when setup asks if you want to
  specify an additional device, and insert the diskette labeled
  'Silicon Image SiI 3112 SATARaid Driver Installation Disk' .

  Press 'Enter' and select
  'Silicon Image SiI 3112 SATARaid Controller'

4. Press 'Enter' to continue on with text mode setup.

5. Follow the setup instructions to select your choice for
  partition and file system.

6. After setup examines your disks, it will copy files to
  Windows 2000 installation folders and restart the system.  
  The setup program will continue and finish the installation
  after restart.

7. Wait until Windows 2000 finishes installing devices, regional
  settings, networking settings, components, and final set of
  tasks, reboot the system if it is required.