Sie sind nicht angemeldet.
Lieber Besucher, herzlich willkommen bei: Aqua Computer Forum. Falls dies Ihr erster Besuch auf dieser Seite ist, lesen Sie sich bitte die Hilfe durch. Dort wird Ihnen die Bedienung dieser Seite näher erläutert. Darüber hinaus sollten Sie sich registrieren, um alle Funktionen dieser Seite nutzen zu können. Benutzen Sie das Registrierungsformular, um sich zu registrieren oder informieren Sie sich ausführlich über den Registrierungsvorgang. Falls Sie sich bereits zu einem früheren Zeitpunkt registriert haben, können Sie sich hier anmelden.
Calibration impulses per liter should be set to 169 not 159. Hope this helps, Other ideas to increase flow would be to reduce or eliminate 90's [use45's if possible], consider adding a second d5 in a dual top if flow is still to low for your liking. This would also give you redundancy if one pump fails.
From what I was told in other forums as well I should expect close to or even over 1GPM!That seems like a pretty low flow number. I haven't hooked any D5's to a flow sensor though, I'm using a MCP35x.
I have all 7/16" ID tubing, guessing 4-5 foot
2xUT60 480mm rads in pedestal (hence the amount of tubing)
cpu block
2xgpu blocks
6x 45's & 3x90"s & 1x5 way "snake" (all rotaries except the drain line)
169 calibration setting for the high flow sensor
my max flow is around 1.2-1.3 gpm.
Just based on past experience with D5's I would think you would get more than 0.4gpm. But that is only a guess. Can you beg, borrow or steal another D5 and stick in the loop and see what 2xD5's does?
-