Aquaero firmware not remembering relay settings!

Lieber Besucher, herzlich willkommen bei: Aqua Computer Forum. Falls dies Ihr erster Besuch auf dieser Seite ist, lesen Sie sich bitte die Hilfe durch. Dort wird Ihnen die Bedienung dieser Seite näher erläutert. Darüber hinaus sollten Sie sich registrieren, um alle Funktionen dieser Seite nutzen zu können. Benutzen Sie das Registrierungsformular, um sich zu registrieren oder informieren Sie sich ausführlich über den Registrierungsvorgang. Falls Sie sich bereits zu einem früheren Zeitpunkt registriert haben, können Sie sich hier anmelden.

virtualrain

Junior Member

Aquaero firmware not remembering relay settings!

Donnerstag, 18. Oktober 2007, 00:06

Hi, both my Aquaero's will not retain the relay settings after a power cycle.

I have tried to set them both to "Power Switch" but everytime the power is cycled on the PC, they come up set to "ATX-Break Line" which renders my PC's power switch unusable. I have been forced to disconnect my power switch from the motherboard and use the powerswitch on the motherboard instead... otherwise I can't even power my computer on.

Thanks for any help with sorting this out.

gr3if

God

Re: Aquaero firmware not remembering relay setting

Donnerstag, 18. Oktober 2007, 01:53

You know that you have to save the settings in the eeprom?

virtualrain

Junior Member

Re: Aquaero firmware not remembering relay setting

Donnerstag, 18. Oktober 2007, 05:15

Yes... good suggestion, but I'm using the "Save data to EEPROM" in the "Extras" menu after adjustments. It seems to remember everything else I set, except for the relay parameters.

gr3if

God

Re: Aquaero firmware not remembering relay setting

Donnerstag, 18. Oktober 2007, 20:11

Hm weird.

Latest Firmware? Latest Aquasuite?

virtualrain

Junior Member

Re: Aquaero firmware not remembering relay setting

Donnerstag, 18. Oktober 2007, 22:31

Yes to both. It also happens on both of my Aquaero's so it's not an isolated problem.

gr3if

God

Re: Aquaero firmware not remembering relay setting

Donnerstag, 18. Oktober 2007, 22:34

Can you check if this is not a cable related issue? Maybe with another cable? And check the pins twice plz.

x-stars

God

Re: Aquaero firmware not remembering relay setting

Freitag, 19. Oktober 2007, 01:38

Long time (about 2 years) ago, but in that times you had to flash the firmware after changing the relais-setting because the aquaero needs to know the settings before booting and thus before there is eeprom-access. So, set it once again to your favourite setting and then reflash the firmware. Don't forget the eeprom-reset afterwards.

"Live free or die: Death is not the worst of evils."

virtualrain

Junior Member

Re: Aquaero firmware not remembering relay setting

Montag, 29. Oktober 2007, 19:17

Zitat von »x-stars«

Long time (about 2 years) ago, but in that times you had to flash the firmware after changing the relais-setting because the aquaero needs to know the settings before booting and thus before there is eeprom-access. So, set it once again to your favourite setting and then reflash the firmware. Don't forget the eeprom-reset afterwards.

This worked. Thanks!