Hello All,


I’ve researched the WEB for hours and come to the conclusion
that for a one-stop solution, you simply can’t better Aquacomputer control products.
The problem for me is that I can’t get to grips with how the components interface
and I clearly need the help of experts such as Shoggy, Sebastian and members of
this Forum.


Initially I envisage a single GPU loop with one EK-CoolStream
RAD XTX 480. I will add a second independent loop later for the CPU and MB
Water-blocks. I use Aida64 for system monitoring.

This is what I’d like to purchase with a view to expansion
later:

Aquaero 6 PRO [don’t need the
remote]

D5 pump motor with USB and Aquabus
interface. Duplicated for second loop.

Coolant temperature sensors, again will duplicate for second loop. I have Bitspower D5 pump tops and reservoirs.


My hope is to program the 6 Pro in such a way as to use the
coolant temperature to control the D5 speed and the radiator fans. Eventually for both loops.

Would anyone be available to give me some direction/guidance
on what I need to purchase to connect these devices and if what I’m suggesting
is even feasible ?

Programming via Aquasuite shouldn’t be too much of a
problem. Famous last words ………….

I also have extra Noctua case fans, all 4 pin PWM
controlled. I think I’m correct in saying that the Pro Console can handle these
independently by means of , ‘Y’ cables, Aida64 etc.

Thank you very much for any help can you provide.

Lyndon

Thanks InfoSeeker, this is very helpful. Seems I'm not the only one with this type of configuration question, after reading your link and other similar items in the Forum. Full credit to Aquacomputer on the h/w front as it backs up my assumption that it's the best out there but complex to configure without detailed knowledge.

I guess my next question would be: If I assume I have two D5's with the USB and Aquabus interface, what are the pros and cons of connecting via USB or the Aquabus interface, assuming both are actually powered via a PSU/Molex connection. I don't see any point in having both connections per pump, but could be wrong.

I will be using the Aquasuite s/w.

LJ.
Superb Forum this, glad I registered.

Shoggy & Infoseeker, thanks for your advice, very much appreciated. For me, the Aquabus connection is clearly the way to go !

Possibly a question for Shoggy:

All my fans are Noctura 4 pin PWM. Are there any know issues with connecting these with the Pro 6 ? I will be grouping together with ModMyToys PCB's, no more than 6 per Aquaero channel. Well within the scope of the console power wise, just wondered if there are know issues with speed regulation etc.

Thanks.

Thanks for your comment Shoggy, puts my mind at rest. All my fans are also < 12 months old so good to go I would think.

I guess what you are saying Jakusonfire, is yes, use the Aquabus connection but only to regulate the pump speed until a sweetspot is found, then hold it. If so, this sounds like good advice as Aida64 will still give me the GPU/CPU temp and the fans can still be regulated.

I have to say the members and content on this Forum are a cut above some of the other Forums I've experienced. Could be the technical nature of the product I guess.