Greetings to all:
I have a loop with 4 blocks (MB, CPU, GPU and the block of aquaero XT) ; one Aqualis reservoir ; one triple and one quadruple rad's ; the loop is moved by 2 pumps MCP-35X with dual top , also has 2 Aquacomputer high flow sensors.
With the pumps to 100%, the yield was 215 l \ h approx.
The reservoir and dual top were joined by two 30 degree fittings , among which there was a very short section of tube that time , when bending over it , notice that it was folding with consequent danger of restriction of flow
I replaced that section of the loop by a combination of fixed parts (some Nozzle adapters coupling , a single fiiting 90 degree swiveling , etc) forming a rigid assembly without the previous danger of the section of tube that was folding .
My problem is that I found the surprise , since idon't find explanation , now only gives me 128 l \ h ............... why I ask whoever helps you could give me an explanation that it could have happened, since I have only a short section replaced by something better and less restrictive .
Of course I checked the operation of both pumps separately and seem fine..
Thanks in advance

Do not think it's because of the debris; only partially empty the liquid loop to just manipulate and replace that section in particular.
And reassembly, I think it is better and eliminates the danger of such a short section of pipe to force curve was done by folding and causing danger flow restriction


http://i44.photobucket.com/albums/f17/do…zps119b0c44.jpg

It's the first thing I did ...................... I checked the two pumps separately; both work and both show similar performance, which makes me think the problem may be elsewhere.
I have also verified that the settings on my XT Aquaero remain correct (flowmeters, controllers, etc ...)

It seems strange ..................... once I came back to fill ,it flush more than two hours with the top fillport open to bleed the loop, even shaking the pc chassis; on the other hand, the loop had only running 3 or 4 months ............ debris problem so quickly? ........ besides, I use distilled water with additive Innovatek Pro and a spiral of silver in the loop
On the other hand, I have a question about my deposit Aqualis XT ............ can I use , in the top of the reservoir, a diferent valve pressure from the one with the reservoir itself ??? .......... this would affect the operation of the fill level sensor?