• 19.08.2025, 19:30
  • Registrieren
  • Anmelden

  • Sie sind nicht angemeldet.

 

Controlling an AquaComputer D5

Kaffefilter5

Newbie

Controlling an AquaComputer D5

Freitag, 17. April 2015, 16:13

So I picked up my new AquaComputer D5 pump with build-in AquaBus and USB support today, and I hooked it up to the "Aquabus High" connector on my Aquaero 5 LT. The pump appears in the pump section in aquasuite, I then set the pump speed to "Set by controller" and added it to a controller based on the CPU temp. When I go to the pumps section in aquasuite, it says that the pump is running at 1-5%, but at 5000+ rpm, which is what it should run at at 100% (pic below). So does anyone have an idea of what I configured wrong in AquaSuite? This pump is obviously supposed to be adjustable, and I want it to run at about 1000-1800rpm at idle.

Thank You in advance! :D


sebastian

Administrator

Freitag, 17. April 2015, 16:20

Try to run the pump in the manual mode. Can you change the pump speed?

Kaffefilter5

Newbie

Freitag, 17. April 2015, 16:24

I set it to manual, and tried 10%, 30%, 50% and 80% power, but it keeps on running at like 5000rpm. Pic below at 50%.

Kaffefilter5

Newbie

Freitag, 17. April 2015, 16:31

Zitat von »sebastian«

Try to run the pump in the manual mode. Can you change the pump speed?
btw thank you for so quick response! Is there an english customer support that I can contact?

EnigmaG

Senior Member

Freitag, 17. April 2015, 17:13

hooked it to the usb and Look for a new firmware.

Kaffefilter5

Newbie

Freitag, 17. April 2015, 17:25

finally got it working! Had to connect it with USB and then change the priority from USB to AquaBus. Thank you very much for very fast response

Ähnliche Themen