ATX break problem

Lieber Besucher, herzlich willkommen bei: Aqua Computer Forum. Falls dies Ihr erster Besuch auf dieser Seite ist, lesen Sie sich bitte die Hilfe durch. Dort wird Ihnen die Bedienung dieser Seite näher erläutert. Darüber hinaus sollten Sie sich registrieren, um alle Funktionen dieser Seite nutzen zu können. Benutzen Sie das Registrierungsformular, um sich zu registrieren oder informieren Sie sich ausführlich über den Registrierungsvorgang. Falls Sie sich bereits zu einem früheren Zeitpunkt registriert haben, können Sie sich hier anmelden.

cincilleo

Junior Member

ATX break problem

Sonntag, 26. Juli 2015, 15:10

Hi all
I'm setting up new configuration with aquaero 5 pro and i have bought an atx break
I have power on aquaero even with the pc turned off and it's ok

I have connected the two n.16 pin (green) to relay port in aquaero.
If i set an alarm with the event realy on the pc turn off for a couple of seconds, then power up again

Now the question is: is possible that pc remain POWER OFF after an alarm? I'm doing something wrong?

Thank you

cincilleo

Junior Member

Montag, 27. Juli 2015, 12:41

no one has the knowledge to reply?

mandrix

Full Member

Montag, 27. Juli 2015, 12:51

Do you have the wiring from pin 16 to the motherboard split at the relay? You must make sure there is not another path for current to travel from the psu to the motherboard.
Without looking directly at yours I don't know what else to tell you.
If you are positive you have it wired correctly, maybe some setting in your BIOS is causing it to restart.

Anyway, I have my Aquaero relay wired directly across the case switch, which to me is the easiest way on my rig. I was going to use the ATX break but this way just seemed simpler to me.

cincilleo

Junior Member

Montag, 27. Juli 2015, 14:45

Yes the aquaero is across the two greens... but when the relay switch on the computer power off the the aquaero turn the relay on and the pc restarts...
So you think is better to connect the aquaero between the power switch? can you send a me photo of your configuration?

Thank u

mandrix

Full Member

Montag, 27. Juli 2015, 17:00

I don't know if the way I did it is better for you. Either way will work.
The forum isn't letting me post a pic from my pc, but basically you just wire the relay across the power and ground...you can do this at the switch or you can do it at the motherboard front panel pins.

cincilleo

Junior Member

Dienstag, 28. Juli 2015, 01:43

what colors and pins are the power switch on the 24 connector?

InfoSeeker

Senior Member

Dienstag, 28. Juli 2015, 15:34

Zitat von »cincilleo«

what colors and pins are the power switch on the 24 connector?

ATX Pinout

cincilleo

Junior Member

Mittwoch, 29. Juli 2015, 14:46

mmm if i short green wire and ground the pc doesn't power on/off...
where is the mistake?

ATX break problem

ATX break problem

Zitat von »cincilleo«

Ähnliche Themen