Sie sind nicht angemeldet.
Lieber Besucher, herzlich willkommen bei: Aqua Computer Forum. Falls dies Ihr erster Besuch auf dieser Seite ist, lesen Sie sich bitte die Hilfe durch. Dort wird Ihnen die Bedienung dieser Seite näher erläutert. Darüber hinaus sollten Sie sich registrieren, um alle Funktionen dieser Seite nutzen zu können. Benutzen Sie das Registrierungsformular, um sich zu registrieren oder informieren Sie sich ausführlich über den Registrierungsvorgang. Falls Sie sich bereits zu einem früheren Zeitpunkt registriert haben, können Sie sich hier anmelden.
Zitat von »GruffDaddy«
Hi!
I'm planning to build a water cooled system using Aqua Computer parts as much as possible. This will be my first water cooled rig. The parts will be purchased in 2 phases due to finances. These are the parts which I plan on getting initially:
Phase I
Case.....Lian-Li PC-G75B
Mobo....Maximus Formula SE
Radiator....Danger Den Black Ice GTX Xtreme (3 x 120mm fans)
Pump....Danger Den DDC-12V REV3.2
Reservoir....Aquabay
Aqua Tube
Aquatube LED Mounting Cap
Blue LED
Tubemeter
CPU Waterblock......Cuplex XT Double Impact
GPU Waterblock......AquagraFX NVIDIA 8800 GTX
Plug&Cool 8mm Fittings...14
Aquastream 3.5" Monitoring Device
Tubing..............7 ft Tygon Premium 3/8" ID
Coolant.............Zertex
Layout will be as follows:
Pump-->Rad-->CPU-->NB-->GPU-->Res-->Pump
1. Will this be enough to get me started?
2. Any suggestions for improving what I have?
3. Where can I get Plug&Cool connectors?
4. Would you suggest a different pump and tubing then the one I have?
Phase II (later on)
Flow Control Sensor & Cable
Thermal Control System
Aquajet
Thermal Sensor
Vario Dual LED
Aquaero Power Connector ATX Standby Relay Cable
Monitor......Aquaero VFD
Control......Multiswitch
Aquastream Controller Board - V3.5
Cable Connector.....Aquabus
Aquaero to Aquastream Cable
Any help would be greatly appreciated! I live in the U.S if that makes any difference such as obtaining parts.
Zitat von »divve«
I'm not sure about your tubing choice. In order for it to be compatible with plug & cool fittings it has to be of the "PUR" type, which is much stiffer/harder with more exacting outer tolerances.
-