• 31.10.2025, 22:43
  • Registrieren
  • Anmelden

  • Sie sind nicht angemeldet.

 

Bug: After Update, Flow Sensor connected on Fan 1 of Aquaero 6 no longer works

GAqua

Junior Member

Bug: After Update, Flow Sensor connected on Fan 1 of Aquaero 6 no longer works

Sonntag, 12. November 2017, 02:31

I have an Aquaero 6. I just updated to Aquasuite 2017-3.1.

I backed up my settings and updated the Aquaero firmware after the software update. I loaded the previous settings back.

Now the flow sensor that was attached to fan1 is no longer working. It thinks its a fan again.

wpuser

Senior Member

Sonntag, 12. November 2017, 03:27

The flow sensor have to be connected to the "aquabus low" port now.

Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »wpuser« (2. Dezember 2017, 19:57)

GAqua

Junior Member

Sonntag, 12. November 2017, 06:31

Thanks, i'll check that out.

GAqua

Junior Member

Freitag, 1. Dezember 2017, 20:10

Zitat von »wpuser«

The flow sensor have to be connected to to "aquabus low" port now.



This indeed works.

While the notes say that you can still use the Fan-1 port for a flow sensor, this is NOT true. If you only have 2 flow sensors, they have to go to the FLOW port and the AQUABUS LOW ports first.

GTXJackBauer

Full Member

Samstag, 2. Dezember 2017, 03:03

Zitat von »GAqua«

Zitat von »wpuser«

The flow sensor have to be connected to to "aquabus low" port now.



This indeed works.

While the notes say that you can still use the Fan-1 port for a flow sensor, this is NOT true. If you only have 2 flow sensors, they have to go to the FLOW port and the AQUABUS LOW ports first.


That's correct.

Ähnliche Themen