• 22.07.2025, 00:22
  • S’inscrire
  • Connexion

  • Vous n’êtes pas connecté.

 

Fan Controller Delay Possible? Stop fans from ramping up and down on Ryzen

KaJ

Newbie

Fan Controller Delay Possible? Stop fans from ramping up and down on Ryzen

samedi 24 octobre 2020, 19:00

So I'm using this software for an air cooled PC right now. I use a virtual CPU/GPU max temp to control most of the fans. However, Ryzen spikes quite a bit into the 70-80*C range and then goes back down to 40-50*C almost immediately. When using my mobo software I just set a fan delay of 2 seconds, so once it hit 70C it would have to hold it for 2 seconds before the fans responded. This meant the fans never kept ramping up and down since it only holds 70*C for a split second. Is this possible to do something similar in Aquasuite X? I am using an Aquaero 6 and a Quadro.

k2viper

Full Member

samedi 24 octobre 2020, 19:04

Use Average(t) and Low pass filter functions in Playground.

KaJ

Newbie

samedi 24 octobre 2020, 19:23

Citation de "k2viper"

Use Average(t) and Low pass filter functions in Playground.
Nice, didn't even know this area existed. Low pass time span lowest time is 5s, seems a little long. No way to lower that value? Also what does the damping number do, can't really tell when I move it up and down (range 0 to 100).

k2viper

Full Member

samedi 24 octobre 2020, 19:45

Damping is "strength" of smoothing.
Try Average(t), it may have lower then 5s time.

mattlach

Junior Member

dimanche 25 octobre 2020, 00:11

I had this issue with one of my pumps.

I just configured a minimum pump speed, and I never had the issue again.

Discussions similaires