My plan is to have 2 water temp sensors one in the aquatube and one just before the rad to see how much heat is absorbed from the cooled components, and see how well the rad is cooling too. Also planning to use the other 4 sensors you get with the Aquatube.

What is the best way to set-up the system and place the temp sensors to turn the radiator fans on when the system gets too hot.

Does the bios temps of the CPU get fed to the Aquaero or do I need to stick a temp sensor on that too, or just concentrate on the actual water temps and cool them.

Any help would be greatly appreciated


SNIFFY

Ok cheers,

Yep I have a flow sensor installed in the set-up along with 6 fans connected to the Evo 360 Rad. 3x 120mm very quiet ones that will run permanently and 3x 120mm normal papst fans to be turned on when the system gets hot. The Rad is also out side the case, I'm just building the box for the Rad now. So hoping that it runs quiet cool.


SNIFFY