This weekend i got all parts from Aqaucomputer. Time to set things up.


Taping the case. We dont need scratches


Marking off the cutting holes


Sawing ;D


Nice holes . Removing tape.


Radiator with Aqautube


Fully loaded system with AC ;D

AqauEaro and Aqaustream controllers + simple revoltec fan controller.


AqauEaro and Aqaustream controllers + simple revoltec fan controller in dark


Side-view


Side-view closeup


Watersplash in Aqautube ;D. Flow rate is about 63,50l/h.


Aqautube with Illumination leds. Dunno how to set only 1 led? Anyone know how to do this?



Some question to AC-Team.

The cuplex XT was delivered with 4 long screws and 2 special shorter screws like the picture below. Also there were 4 big springs and 2 shorten springs.

So far i know the 2 special shorter screws are for the stablisation plate behind the mainboard. You can just screw then into it. But you need also 4 of them to get the Cuplex XT AM2 perfectly fitted on the CPU Core.

I putted so long 1 screw upperleft and the other down right. It cools enough for at 39C idle, but when i give pressure on the empty holes my temperature getting lower.

So how can i get 2 more screws and 2 short springs(most left side of the picture) like shown on the picture below. I dont wanna use the 4 longs screws, because this dont give enough stabilsation on my mainboard and i want to keep the stabilization shield behind the mainboard. I think its better to include in the future 4 long , 4 of that special screws, 4 short springs, and 4 long springs, because every AM2 board got this standard.

I sended an email about the screws to Support. Btw, can i get also Artic Silver 5 from the shop?

This was already alot of money. I think in spring 2007 i buy some more blocks.

Still didnt recieved anything about those screws