Sie sind nicht angemeldet.
Lieber Besucher, herzlich willkommen bei: Aqua Computer Forum. Falls dies Ihr erster Besuch auf dieser Seite ist, lesen Sie sich bitte die Hilfe durch. Dort wird Ihnen die Bedienung dieser Seite näher erläutert. Darüber hinaus sollten Sie sich registrieren, um alle Funktionen dieser Seite nutzen zu können. Benutzen Sie das Registrierungsformular, um sich zu registrieren oder informieren Sie sich ausführlich über den Registrierungsvorgang. Falls Sie sich bereits zu einem früheren Zeitpunkt registriert haben, können Sie sich hier anmelden.
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »Timstone« (19. April 2009, 11:33)
Holy, holy...
Could someone please answer my questions in the way I posted them in the first place?
No harm intended from my side, it's just easier for me to read that way.
Hi all,
These are my questions:
- Which pump to chose?
- Which diameter tubes to chose?
- How many temperature sensors, where to place them and which kind to chose?
- Which kind of flow sensor to chose?
- Is the setup I chose correct?
- Did I forget somehting?
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »fox3« (19. April 2009, 18:11)
Hi all,
It has been some thime since I posted here. But now I'm going to overhaul my system big time, I need some advise. Here it goes!
This is what I want:This is the setup I have in mind:
- PC-A77B case
- CPU cooler
- 2 GPU coolers
- Pump is automaticly regulated by the water temperature
Radiator --> CPU --> GPU I --> GPU II --> Temp. sensor --> Reservoir --> Pump --> Flow sensor -->
These are my questions:
- Which pump to chose?
- Which diameter tubes to chose?
- How many temperature sensors, where to place them and which kind to chose?
- Which kind of flow sensor to chose?
- Is the setup I chose correct?
- Did I forget somehting?
Dieser Beitrag wurde bereits 5 mal editiert, zuletzt von »Top_Nurse« (20. April 2009, 10:12)
Dieser Beitrag wurde bereits 4 mal editiert, zuletzt von »drbo« (24. April 2009, 00:15)
Hi,
I have run several setups on my complete wc workstations, and years of experience has given me this rule of thumb regarding cooling power - in terms of how much radiator is needed (meassured in # of 120mm fans over radiator). This rule has hold nicely so far with both amd and intel cpus. The internal temp sensor of the aquastream I don't trust, since it always showed far to high temp compared to my other 4 sensors, and also the temp differense was not stable .
-