For your display issue I'm guessing when you touch the screen to scroll to another choice the 2 sec duration no longer applies. It shows what you selected and then if nothing is touched it goes back to default after a time which appears to be roughly a minute. If you are wanting your temp sensors to show up on their own my suggestion is this. Set a time duration for the clock which would presumably be a high number and then keep the 2 sec dur for the temp. Ex. I like temps showing most of the time but also like to check in on the clock/flow/and fans. I set the last three to a 3 sec dur each and the temp one to 120 sec. This lets me see the temps most of the time but if i watch for 2 minutes i can get a quick glance at the other stuff. Another option is to make a couple of windows in Overview to be displayed on your desktop at all times. My pc recently moved to far from me to see the screen and i have found the screen displays invaluable.

Zitat von »Mafia«

I can not find aquacomputerTimeSync.exe in my program file, i guess this has been removed now. So do we have to run Aquasuite 2012 at every boot now?

This is replaced by aqua comuter service. When the service is running your device will be automatically synchronized.

Zitat von »Mafia«

For my display I have selected 2 screens. Time (which has Permanent ticked) and Software sensor 1-4 temperature (Permanent unticked and duration set to 2 seconds), when I click up or down on the touch screen the Software sensor temperature stays for longer than 2 seconds, in fact it stays for around 30 seconds to 1 minute.

In the youer interface page is a time: "Display duration after page selection"