• 18.07.2025, 07:07
  • S’inscrire
  • Connexion

  • Vous n’êtes pas connecté.

 

Small technical issue - usb not detected

r3volt97

Junior Member

Small technical issue - usb not detected

mardi 29 mars 2022, 09:52

Morning guys ,

i happen to get the USB not detected error for my D5 Next and Leakshield and not sure how can i solve it properly , what are the known issues please ?

I've had the update machine time error before getting this type of error , i've updated date and time from the BIOS but now i came across the detection error for some reason , they're hooked to my Silverstone remote control hub .

InfoSeeker

Senior Member

mardi 29 mars 2022, 15:32

My first check would be to bypass the Silverstone USB hub, and connect the D5 &/or leakshield directly to a USB port on the mobo.

r3volt97

Junior Member

mercredi 30 mars 2022, 14:59

It's working , can i have it connected on the same usb one above each other as i need to have the remote control board plugged as well .

Also , i've installed the latest update for Xsuite or whatever , which is released this month , if anything new releases and i update it will void my licence right ?

InfoSeeker

Senior Member

mercredi 30 mars 2022, 18:20

Citation

can i have it connected on the same usb one above each other as i need to have the remote control board plugged as well
Yes, both 5-pin connectors from the 2 aquacomputer devices may be plugged into a single motherboard USB 2.0 connector.

Citation

i've installed the latest update for Xsuite or whatever , which is released this month , if anything new releases and i update it will void my licence right?
Your license will never be voided. The license is tied to aquacomputer gear. You can see when your license expires on the aquasuite>Updates tab.
Your license (no cost updates) are good to the date farthest-out in the list. For me that is 2022.10.05. (license.jpg)
If you want to update after expiration (aquasuite &/or firmware), you will need to purchase another 1 year term.

Licensing is discussed HERE.

Ce message a été modifié 1 fois. Dernière modification effectuée par "InfoSeeker" (30 mars 2022, 18:34)

r3volt97

Junior Member

jeudi 31 mars 2022, 01:03

Understood , now tell me : which way does the leakshield steps go . Do i run deaeration with the system on or off ? Is target temperature mode wise to use or should i stick with power preset if i have good temps and i don't want the pump to be loud . I've ran the pump at both 100% power preset and 50% and there's not big difference , it's my first WC build so i'm not aware of most of the scientific stuff i'd say . My system is a non OC'ed 5950X and Red devil 6800 cooled by an Alphacool ST30 with Phantek's T30's .

r3volt97

Junior Member

jeudi 31 mars 2022, 05:07

If i want Fabwerk strips , is this totally required in order for RGB Fusion software to control everything ?

aqua computer Adapter für RGBpx-Komponenten an 3-Pin RGB Anschluss (5VDG, 5V)

InfoSeeker

Senior Member

jeudi 31 mars 2022, 05:59

I am not ignoring you, but you are asking questions I am not competent to answer. Hopefully someone who is will reply.

Discussions similaires