Problem Using Fans with no RPM feedback (Aquaero)

Yellowsnow17

Junior Member

Montag, 21. März 2005, 20:09

1

Hello All,

The title says it all. I am using my Aquaero with fans that do not have rpm feedback. When I try to control the speed of the fans manually, I can only make them turn full speed or off. How can I go about regulating the speed of my fans with the Aquaero? I am using some Panaflo L1A's that do not report rpm feedback.

Ich bin Ausländer und sprechen nicht gut Deutsch

Yellowsnow17

Junior Member

Re: Problem Using Fans with no RPM feedback (Aquae

Dienstag, 22. März 2005, 19:17

2

Come on, I know there are a lot of smart people on these boards.

Ich bin Ausländer und sprechen nicht gut Deutsch

CyberXY

God

Re: Problem Using Fans with no RPM feedback (Aquae

Dienstag, 22. März 2005, 19:32

3

I think its not possible, because the aquaero has to know at how many RPMs the fans are running at in order to regulate them to a another RPM. I hope you understand my english

Dragonclaw

God

Re: Problem Using Fans with no RPM feedback (Aquae

Dienstag, 22. März 2005, 19:50

4

there schould be a posiblity to control them.

if you hav no rpm signal, there is an option to set how much power the fans shall get at least. set it to a value where the fans rotate, then it should work...

Verwende keine sinnlose Gewalt. Hol einen größeren Hammer.

Yellowsnow17

Junior Member

Re: Problem Using Fans with no RPM feedback (Aquae

Freitag, 25. März 2005, 01:36

5

Thanks for the suggestions, however I tried setting the power manually and it doesn't work. Does anyone else have an idea what might be going on?

Ich bin Ausländer und sprechen nicht gut Deutsch