Sie sind nicht angemeldet.
Lieber Besucher, herzlich willkommen bei: Aqua Computer Forum. Falls dies Ihr erster Besuch auf dieser Seite ist, lesen Sie sich bitte die Hilfe durch. Dort wird Ihnen die Bedienung dieser Seite näher erläutert. Darüber hinaus sollten Sie sich registrieren, um alle Funktionen dieser Seite nutzen zu können. Benutzen Sie das Registrierungsformular, um sich zu registrieren oder informieren Sie sich ausführlich über den Registrierungsvorgang. Falls Sie sich bereits zu einem früheren Zeitpunkt registriert haben, können Sie sich hier anmelden.
Zitat von »Shoggy«
Default is 519 Imp/L and you only need to change it if you use an other sensor than the sensor from AC or if you have modified it.
Zitat von »x-stars«
No, according to the manual at digmesa and the aquasuite-standard it's 509 .
You can drill your sensor input to get the 3,3mm-Input bigger - then you should chage in and out and fix the Impulse/L to 256 (so you don't need to check your sensor manually, 'cause the output is 5,6mm and 256 the official Digmesa-value). But keep in mind: To my and the experience of some other a drilled sensor doesn't rule at all - I have the same flow-rate as before (in truth, it's a little less ).
Zitat von »Top_Nurse«
Something is not right if you increase the surface area of the intake 40 percent and get less flow. ??? Did you do a quanitative measurement to make sure you are getting less flow or did you just depend on what the Aquaero reports? Perhaps the IPL is not correct.
-