• 20.07.2025, 13:28
  • S’inscrire
  • Connexion

  • Vous n’êtes pas connecté.

 

Controlling DDC pumps using aquabus

spalex

Newbie

Controlling DDC pumps using aquabus

dimanche 2 avril 2017, 10:27

Hi guys


I am new to this, but I seem to have figured it all out without any problems.

The only thing I need help with is controlling my pump speed using the aquero 6.

My pump is an EKWB DDC 3.2 pwm pump.

When it is connected to my motherboard it works fine, changes speeds.

But I have connected it to the aquabus high header on the aquero, and it just runs at full speed.

In the aquasuite software, nothing comes up when I click on pumps. Or when I click on Aquabus.

What am I doing wrong / forgetting?

sebastian

Administrator

dimanche 2 avril 2017, 11:38

Citation de "spalex"

But I have connected it to the aquabus high header on the aquero, and it just runs at full speed.
Disconnect it NOW!

The aquabus is no PWM Controll connection. You can destroy your aquaero and your Pump.

GTXJackBauer

Full Member

dimanche 2 avril 2017, 12:58

Citation de "sebastian"

Citation de "spalex"

But I have connected it to the aquabus high header on the aquero, and it just runs at full speed.
Disconnect it NOW!

The aquabus is no PWM Controll connection. You can destroy your aquaero and your Pump.


This.

Fieldrider

Senior Member

dimanche 2 avril 2017, 17:15

And then, try to connect it to Fanport 1.

spalex

Newbie

lundi 3 avril 2017, 16:01

It's okay. I only had it connected for a short time before I realised it was not working.

I plugged it back into the motherboard header.


I will try to configure it using the fan connections on the aquero.

Thanks for the info guys

Discussions similaires